Section 1 - Material Identity

Product Name:        Sealant

Product Use:           Polishing Compound

Manufacturer’s Supplier’s Name & Address

Telephone Number – (714) 742-6792

Hot Wax Distributors

P. O. Box 1008

Stanton, CA  90680

Days:      (310) 515-9530

Nights:    CHEMTREC: 800/424-9300

DOT Proper Shipping Name:                 N/A

EPA Hazardous Waste Class:                Not Regulated

DOT Shipping ID Number:                                    CFR 49

Section 2 - Physical & Chemical Characteristics

Vapor Density (air=1): Heavier than air

Solubility in Water by Weight: Medium

Boiling Point: 760 mmHg        N/A

Appearance and Odor:              A white-colored semi-solid suspension with a mild chemical odor

Specific Gravity:      No data

Freezing Point:                                        N/A

Vapor Pressure at 20°C: No data

Percent Volatile by Volume:     20%

Evap. Rate (Butyl Acetate=1): Slower than ether

Section 3 -Ingredients & Specifications

Materials       

             %

      TVL Units

         Hazard

       CAS Number

Mineral Spirits

100ppm

8052-41-3

Section 4 - Fire & Explosion Hazard Data

Flash Point & Method:            200-F PMCC

Extinguishing Media:                                Dry chemical, carbon dioxide, sand or earth.  Water and foam may cause frothing.

Special Fire Fighting Procedures:              Fire Fighters should wear self-contained breathing apparatus and protective equipment.  Use water spray to cool fire-exposed containers, to dilute and disperse vapors, protect personnel and to dilute and flush spills away from fire.

Unusual Hazards:                                      N/A

Flammable Limits in Air % by volume:                                    Lower: N/A              Upper: N/A

Section 5 - Health Hazard Data

Route of Entry        

a) Skin:                    Ingestion 

Effects of Acute Exposure: This material is not hazardous as defined by OSHA 

a) Skin Contact:       Prolonged skin contact may cause mild transient irritation

b) Eye Contact:        May cause burning, tearing and redness

c) Swallowing:          May cause mild irritation of the stomach and intestinal tract

d) Skin Absorption: N/A

e) Inhalation:           Prolonged exposure to vapors may cause irritation of the nose and throat, drowsiness and dizziness.

Chronic Effects of Overexposure:

Petroleum fractions similar to the middle distillate components of this material have been shown to cause skin cancer in laboratory animals.  Because of physical nature of this material contact with this component is unlikely.

Other Health Hazards:

N/A

Emergency and First Aid Procedures: If victim is not breathing or if breathing difficulties develop artificial respiration or oxygen should be administered by qualified personnel.

a) Skin:    Wash affected skin area(s) with soap and water.  No additional first aid is normally required.

b) Eyes:    Flush affected eye(s) with water.  If irritation or redness develops, seek medical assistance.

c) Swallowing:          If victim is conscious and alert, give milk or water to drink.  Seed medical assistance.

d) Inhalation:           Move away from source of exposure.  If symptoms of exposure develop and persist, seek medical assistance.

Carcinogen Evaluation

Raw material components contained in this product are not known or suspected to be carcinogens.  Proposition 65: Ethyl acryl ate is known in the State of California to cause cancer.  This product contains negligible tract amount of ethyl acryl ate.

Section 6 - Reactivity Data

Stability -

Stable under normal conditions of storage and handling

Conditions to Avoid for Stability

See below

Incompatibility (Materials to Avoid) -

Strong Oxidizing Agents

Hazardous Polymerization -

Will not occur

Hazardous Decomposition/Byproducts

Burning produces carbon dioxide and carbon monoxide

Section 7 - Spill or Leak Procedures

                      Release/Spill

                       Procedures

Steps to be Taken: Pick up spills using an absorbent material and package for disposal

Waste Disposal Method: Dispose of in accordance with federal, state and local regulations.  This material is not a hazardous waste.

Section 8 - Special Protection Information

Eyes:        None normally required

                       Protective

                       Equipment

Respirator: None normally required

Gloves:     Protective gloves are recommended to minimize prolonged skin contact

Other:      An eye wash and a source of running water should be available to wash or flush the eyes and skin

                       Ventilation

General Mechanical: General dilution or mechanical ventilation is recommended

Other:

Section 9 - Special Precautions

                       Handling &

                          Storage

General:   Store in closed containers in a cool, dry, well-ventilated area.  Use good personal hygiene.  Avoid eye or prolonged skin contact.  Wash thoroughly after handling.

Other:                                      N/A

Section 10- Other Information

The information contained herein is based on data considered accurate.  However, the information is provided without any warranty, expressed or implied, regarding its correctness.  The conditions or methods of handling, storage, use and disposal of the product are beyond our control and may be beyond our knowledge.  For this and other reasons, we do not assume responsibility for personal injury or property damage to vendees, users or third parties caused by the material.  We also do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product.

 Prepared By:  Jet Shine Wax Products, Inc.

 New/Revision Date: 09/17/2009